Installation

General performance

Savings rate:

Up to 100% water savings of water used in the sink

Water flow:

Up to 7 l/min

Temperature range:

Typically 4-55°C, depending on local water supply

Size and weight

Faucet:

162 x 169 x 155 mm, 1.5 kg

Mixer:

310 x 190 x 65 mm, 2.1 kg

Tank:

440 x 270 x 65 mm, 1.2 kg

Pump:

197 x 296 x 140 mm, 3.5 kg

AC/DC power supply:

152 x 63 x 30 mm, 420 g

Water supply

The water supply determines the available flow and temperature from the faucet

Incoming Hot & Cold water:

Recommended flow: 5-8 l/min

Recommended incoming water pressure: 2-5 bar

Maximum working pressure: PN10

Hot water temperature (min-max): 50-65°C

Cold water temperature (min-max): 4-25°C

Water connections (Mixer and Faucet):

G 1/2 threads (ISO 228/1-G 1/2” external threads)

Water connections (Tank and Pump):

G 1/2 threads (ISO 228/1-G 1/2” external threads) and G 3/8 threads (ISO 228/1-G 3/8” external threads)

Water hardness:

3°dH-14°dH.

If the local water hardness on the installation site is more than 14dH it is recommended to install a water softener.

Recommended power supply

100-240V, 50/60Hz, 2.5A, 120W

Power consumption:

Mixer unit; active mode: nominal 5W, max. 20W; standby mode: 1.8W

Tank and Pump unit; active mode: nominal 25W, max. 70W; standby mode: 0.21W

Installation area

Full system:

All components are wall mounted: behind commode, below wash basin or up to 3 m from the wash basin. The top inlet in the Tank needs to be placed at a lower point than the outlet from the wash basin. The Mixer needs to be placed at the same height or lower than the Faucet. The Pump needs to be placed within 6 m from the toilet cistern. The Faucet is sink mounted.

Connectivity

Internet connection:

Password protected 2.4 GHz Wi-Fi network or Ethernet

Maintenance

Cleaning tablet:

Add in the sink at regular intervals to both clean the product and get a fresher bathroom experience. The frequency depends on usage and preference.

Fresh Mesh:

Cleaned by hand, in a dishwasher, or replaced when needed. The frequency depends on usage; typically once per month. It’s important that the Fresh Mesh is not emptied and cleaned in the wash basin.