Skip to main content

Installation

Install Tank
  1. Before drilling, make sure the components fit and that the overflow outlet on the Tank is located at a higher point than the drain.

    240112-Fit_component_in_commode_Tank.eps
  2. Pre-drill holes for the Tank fastening kit.

    Caution

    • The length of the plugs is 40 mm. Adapt placement according to the piping.

    • Make sure the two holes are vertically aligned to ensure the Tank is not tilting.

    231009_Tank_fastening_kit_measurements.eps
  3. Insert the plugs, screws, and the long spacers.

    231009_Tank_fastening_kit_attach_screws.eps
  4. Attach the Tank. Add the thin washers, and secure with the nuts.

    231009_Attach_tank.eps