Skip to main content

Installation

Install the sensor cable, flush hose and recirculation hose
210521_Install_shower_Unit_hoses_with_black_cover_and_barb.eps

  1. Remove the protective film and lift up the drain grate and Funnel. Set them aside.

    230427_Panel_Tiling_Frame_Set_Remove_Protective_Cover.eps
    230427_Shower_unit_Panel_inst_drain_hoses_and_cables.eps

  2. Install the sensor cable. Make sure the sensor cable goes first and that the connector protection cover is on.

    Notice

    It is recommended to use fish tape to route the cables through the pipes.

    201104_Shower_unit_inst_drain_hoses_and_cables_2.eps

  3. Install the flush hose and recirculation hose.

    210519_Shower_unit_inst_drain_hoses_and_cables_R3.eps

  4. Pull the sensor cable to where 20 cm of slack is visible.

    201104_Shower_Unit_inst_sensor_cable_black_cap_added_sensor_cable.eps