Skip to main content

Installation

Prepare shower area

  1. Frame the shower area.

    210429_Standard_prepare_shower_area_floor_x_millimeter.eps

  2. Mark the floor level where the waterproofing will be connected to the drain unit flange. This mark will be used as measurement "X" in the installation process to ensure that there is enough space for the drain unit.

    210420_Prepare_shower_area_mark_x.eps

  3. Install noggings.

    Caution

    It is crucial that all nogging pieces are level and set according to recommended measurements to avoid misalignment in the shower installation.

    210504_Standard_prepare_shower_area_noggins_2_millimeter.eps

  4. Frame the area where the Wall Box will be installed.

    Make sure the Wall Box will fit inside the wall. See chapter Kit measurements for correct measurements.

    240301-Prepare_installation_area_Hatch.eps

  5. Drill holes in the studs in between the shower area and the place where the Core will be installed.

    Notice

    Adjust slot in studs and wall covering depending on hand shower and Control Dial placement.

    210323_Standard_prepare_shower_area_slots.eps
    Figure 33. Only valid for Orbital Audio installation

    Drill additional holes for the speaker cable.

    Only valid for Orbital Audio installation


  6. Apply wall covering according to the illustration. Follow industry rules.

    210414_Standard_prepare_shower_area_drain_wall_covering_millimeter.eps

    z_box.eps The hole is centered in the shower area.