Skip to main content

Installation

Install Control Dial
210420_R3_OPU_comp_overview.eps

Notice

Do not remove the protective cover from the Control Dial until the installation is completed.

  1. Secure the bracket using the four screws provided.

    221123_R3_Panel_Shower_Unit_inst_control_dial_mount.eps

    x4

    Plastite screw

  2. Draw the cable through the bracket and the door.

    221110_Panel_R3_Shower_Unit_inst_control_dial_mount_2.eps

  3. Position the Control Dial according to the “up marking” before assembly. Snap the Control Dial onto the fixture, and make sure to align the brackets according to the arrows.

    210510_R3_1-04-0063_OPU_wall_mount_Up_direction_no_screws.eps

  4. Fit the cable in the channel on the inside of the door.

    210421_R3_Indo_shower_unit_inst_11.eps

  5. Connect the Control Dial cable to the red connector. Proceed by connecting the Sensor Tank cable to the blue connector.

    Caution

    Make sure to have correct alignment between key and slot in connectors. Make sure locking ring snaps and connector is locked.

    240315-Connect_sensor_tank_control_dial_and_audio.eps

  6. Only valid for Orbital Audio Installation

    Connect the amplifier cable to the yellow connector.

    230619_Connect_Amplifier_to_Core.eps