Installing the diverter and hand shower
 |
Diverter body, x1
O-ring, x2
Diverter wall plate, x1
TX25 screw, x2 and twin washer, x1
Hand shower, x1
Shower hose, x1
Cut the conduits to a minimum of 6 mm and a max of 9 mm outside of the tile surface.
Push the PEX pipes in until it stops, and cut them 25 mm outside the tile surface. Deburr and calibrate the pipes.
Caution
It’s important that the PEX hoses are pushed in all the way to ‘stop’ before cutting.
Measure and mark the hole positions for the diverter.
Mark hole positions for the hand shower holder.
Drill four holes (6 mm) in marked locations.
Caution
Only drill through the tile itself.
Seal drill holes in accordance with applicable industry standards. See section Seal mountings in wet zone for instructions.
Mount the diverter wall plate.
Caution
Use 2x included screw, choose screw according to wall thickness.
x2
TX25 stainless steel screw
x1
Twin washer
Secure the diverter body to the diverter wall plate using an Allen key (3mm).
Install the hand shower to the diverter.
