Skip to main content

Installation

Install Control Dial
220507_R3_Standard_Control_Dial_Comp_Overview.eps

  1. Cut the conduit flush to the tile surface.

    210430_Install_Diverter_Cut_sleeve.eps

  2. Level the fixture and make sure it is centred on the hole in the wall. Measure and mark the outer holes.

    210119_Remote_Cabinet_R3_OPU_bracket_alignment.eps

  3. Drill 4 holes (4,0 mm) in the marked locations, and mount the bracket with the screws supplied.

    Caution

    • Only drill through the tile itself, no deeper.

    • Seal drill holes according to industry rules. See section Seal mountings in wet zone for instruction.

    191217_R3_Remote_Shower_Unit_inst_control_dial_mount_1.eps

    x4

    TX screw A4 (38 mm)

  4. Connect the Control Dial cable to the extension cord.

    230119_Cabinet_Hatch_R3_inst_Control_Dial_extension_cord.eps

  5. Pull the cable through the conduit.

    Notice

    It is recommended to use fish tape to route the cables through the pipes.

    191209_Remote_pre_inst_piping_OPU.eps

  6. Position the Control Dial according to the “up marking” before assembly. Snap the Control Dial onto the fixture, and make sure to align the brackets according to the arrows.

    210510_R3_1-04-0063_OPU_wall_mount_Up_direction_no_screws.eps

  7. Connect the Control Dial cable to the red connector. Proceed by connecting the Sensor Tank cable to the blue connector.

    Caution

    Make sure to have correct alignment between key and slot in connectors. Make sure locking ring snaps and connector is locked.

    240315-Connect_sensor_tank_control_dial_and_audio.eps

  8. Only valid for Orbital Audio Installation

    Connect the amplifier cable to the yellow connector.

    230619_Connect_Amplifier_to_Core.eps