Install drain
 |
Caution
Plumbing and electrical installation should be performed according to industry rules.
Do not remove the protective cover until the frame is being installed in a later step.
Secure the outlet unit in place using the two hooks at the bottom of the drain. Insert the water trap, and then fold the protective film back to cover the drain unit.
Use all supplied screws (7) to fasten the drain unit to the wall.
The floor level where the waterproofing is connected to the floor drain flange.
Drain unit is centered in the shower area.Connect the drain unit to the sewerage system as defined by industry rules.
 |
Anchors
2
Perform the installation in accordance with current Industry Rules Säker Vatten Installation. See bulleted list 2 in chapter Important installation steps.
Attach the drain pipe to the back of the drain unit.
Note
Apply Glidex lubricant when assembling.
Anchor the pipes and fittings according to industry rules.
Caution
Make sure to fasten and anchor the pipes and fittings so they cannot move or be separated.
Perform a leakage check to eliminate leakage.
Caution
For installations in Sweden leakage test shall be performed. The drain must be sample flushed and inspected visually to ensure that the assembly is tight. The leakage test shall be documented.
