Skip to main content

Installation

Install drain
Figure 12. Drain unit and outlet unit
Drain unit and outlet unit


Caution

  • Plumbing and electrical installation should be performed according to industry rules.

  • Do not remove the protective cover until the frame is being installed in a later step.

  1. Secure the outlet unit in place using the two hooks at the bottom of the drain. Insert the water trap, and then fold the protective film back to cover the drain unit.

    240213-Insert_Outlet_unit.eps

  2. Use all supplied screws (7) to fasten the drain unit to the wall.

    241128_install_drain_level_millimeter.eps

  3. Connect the drain unit to the sewerage system as defined by industry rules.

    201209_install_drain_connect_drain.eps
Figure 13. Drain piping
Drain piping


. Provided by Customer:

  • Anchors

2

Perform the installation in accordance with current Industry Rules Säker Vatten Installation. See bulleted list 2 in chapter Important installation steps.

  1. Attach the drain pipe to the back of the drain unit.

    Note

    Apply Glidex lubricant when assembling.

    2104281616_R2_Indo_preinstallation_drain_pipes.eps

  2. Perform a leakage check to eliminate leakage.

    Caution

    For installations in Sweden leakage test shall be performed. The drain must be sample flushed and inspected visually to ensure that the assembly is tight. The leakage test shall be documented.

    240409_R3_Panel_pre_inst_water_leakage.eps