Skip to main content

Installation

Prepare for tiling

  1. Raise the floor until it is level with the flange on the drain unit.

    191119_Remote_pre_inst_raise_floor.eps

  2. Form a steep inclination towards the drain unit in accordance with applicable industry standards (min. 2% inclination). Make sure that the lowest part of the inclination is level towards the drain unit surface.

    201201_Standard_prepare_tiling_inclination.eps

  3. Apply wall covering in accordance with applicable industry standards. Drill the holes using a drill with a maximum diameter of 25 mm.

    210325_Remote_pre_inst_wall_covering_center.eps
    Figure 43. Only valid for Orbital Audio installation

    Caution

    Make sure to apply construction glue to all wallboard layers.

    Only valid for Orbital Audio installation


  4. Mount plasterboards around the Wall Box.

    Note

    Note that the wall covering should not end edge to edge with the outside of the cabinet. When correctly mounted, the frame of the cabinet lands on the plasterboards.

    210107_Remote_Cabinet_cover_wall.eps