Skip to main content

Installation

Installing the metallic shower head
Figure 25. Component Overview
Component Overview


  1. Threaded adapter

  2. Head shower internal PEX pipe with gasket

  3. Head shower arm insert with support ring

  4. Metal cover

  5. Shower head

  1. Cut the wallbox UNI Push so that it protrudes 6-9 mm. We recommend using the LK Wallbox Cutter UNI.

    241202_shower_head_inst_1.eps

  2. Fit the threaded adapter into the UNI Push wallbox, so that it protrudes 30-55 mm from the wall surface. Cut it if needed.

    Note

    Cover the end of the threaded adapter with thread sealant to avoid leakage.

    241202_shower_head_inst_2.eps

  3. Fit the head shower arm insert onto the adapter. Then loosen about half a turn to adjust the angle.

    Caution

    Make sure that the support ring is in place, and that the rubber side is facing the wall.

    241202_shower_head_inst_3.eps

  4. Adjust the angle using the set screws.

    Note

    The head shower will add some weight. Adjust the angle of the arm slightly upwards to compensate for the added weight.

    241202_shower_head_inst_4.eps

  5. Push the PEX pipe into the shower arm insert. Be careful not to break the pins.

    241202_shower_head_inst_5.eps

  6. Fit the metal cover over the shower arm insert.

    241202_shower_head_inst_6.eps

  7. Fit the shower head onto the shower head arm. Check the angle with a spirit level.

    Caution

    Make sure the gasket is in place, not to cross thread, and not to overtighten.

    201118_head_shower_install_3.eps