Install Orbital Shower Core
 |
Cut the recirculation hose and flush hose according to the measurements below, depending on the installation scenario.
Apply fitting grease to the separate hose coupling, push all the way into the circulation hose and tighten with the hose clamp.
Insert the Core into the Wall Box and attach the safety wire. Keep tilted to enable electrical installation.
Caution
Heavy equipment. Orbital Shower Core weighs approx. 25 kg.
Make sure that hoses and cables are not pinched.
Measure and mark the pipes for cutting.
Cut the PEX pipes. Lift the Core out of the Wall Box for better access.
Install the connectors.
Caution
Install hose connections according to industry rules.
Make sure to flush out the water lines from debris before connecting the Core.
Remove the transport plugs before starting the installation.
Insert the Core into the Wall Box and attach the safety wire. Keep tilted to enable electrical installation.
Caution
Heavy equipment. Orbital Shower Core weighs approx. 25 kg.
Make sure that hoses and cables are not pinched.
Connect the power cable to the junction box.
Connect the Wi-Fi antenna cable.
Lock the Core in place.
Connect incoming and outgoing water to the Core.
Connect the recirculation hose and flush hose to the bottom of the Core.
- Figure 43. Only valid for Orbital ethernet installation
Pull the ethernet cable through the cable connector and attach the RJ45 connector.
Unscrew the protective cover.
Hand tighten the cable connectors to avoid damage.
