Skip to main content

Installation

Installing the diverter and hand shower

  1. Cut the conduits to a minimum of 6 mm and a max of 9 mm outside of the tile surface.

    220125_Install_Bypass_block_Cut_sleeve.eps

  2. Caution

    • It’s important that the PEX hoses are pushed in all the way to ‘stop’ before cutting to the correct length of 25 mm.

    • Make sure the pipe is cut straight and avoid too many degrees. A PEX pipe bevel tool is recommended to avoid damage to o-rings.

    220131_Install_cc60_cut_18_millimeter_length.eps

  3. Measure and mark the hole positions for the diverter.

    220128_R3_cc60_assembly.eps

  4. Mark hole positions for the hand shower holder as well.

    220202_Install_cc60_Diverter_mark_drill_holes_millimeter.eps

  5. Drill four holes (6 mm) in marked locations.

    Caution

    • Only drill through the tile itself.

    • Seal drill holes according to industry rules. See section Seal mountings in wet zone for instructions.

    220131_Install_cc60_drill_holes.eps

  6. Mount the diverter wall plate.

    Caution

    Use 2x included screw, choose screw according to wall thickness.

    220131_Install_cc60.eps

    x2

    TX25 stainless steel screw

    x1

    Twin washer

  7. Secure the diverter body to the diverter wall plate using an Allen key (3mm).

    220201_Install_cc60_o-ring.eps

  8. Install the hand shower to the diverter.

    220202_Install_cc60_hand_shower_cable.eps