13. Filter
This instruction shows how to swap the Filter in a Hatch Tiled installation. The Core and Filter can be placed either inside or outside of the shower area. Follow the instructions in detail, and don't hesitate to reach out if you have any questions - support@orbital-systems.com.
Use the kit below to swap the Filter.
Filter Capsule |
Swap Filter
Push the top left corner to tilt the door open. Lift the door off the lower brackets. Be aware that the weight of the door is 8-12 kg, depending on the tile thickness.
Caution
The weight of the Hatch Tiled door is approximately 8-12 kg, depending on the tile thickness. Be careful when lifting.
Open the filter door and release the filter holder.
Remove the old Filter Capsule
Insert the new Filter Capsule.
Caution
Ensure that the Filter Capsule is correctly inserted to avoid leakage. The plastic ring should be placed downwards.
Close the filter holder and filter hatch.
Secure the door onto the brackets, tilt it inward to close it, and press the upper left corner to lock it in place.
Complete and submit the service report (found in the service request).
Recycle the replaced Filter.
