8. Head shower
This instruction shows how to swap the head shower. Follow the instructions in detail, and don't hesitate to reach out if you have any questions - support@orbital-systems.com.
Use the following kit to swap the hand shower. This kit is available in several color variants.
Shower head |
Head shower arm |
Threaded adapter |
Dismantle head shower
Unscrew the shower head.
Screw down the shower arm.
Screw down the threaded adapter.
Note
If the threaded adapter is undamaged, it should be reused and does not need to be replaced, unless otherwise specified in the work order. This step and step 1 under "Installing the overhead shower" only apply when replacing the threaded adapter.
Install head shower
Step 1 only applies if the threaded adapter is to be replaced.
Fit the threaded adapter. Cover the end with thread sealant to prevent leakage.
Install the shower arm.
Caution
Apply fitting grease to the end of the PEX pipe.
Check that the gasket is in place and fit the shower head.
Start the shower and switch to shower head mode. Ensure that there is no leakage between the wall and the shower arm and between the shower head and the shower arm.
Turn off the shower.
Complete and submit the service report (found in the service request).
Recycle the parts and components that should not be reused.
