5. Diverter - 40 CC
This instruction shows how to swap the diverter (40 CC version). Follow the instructions in detail, and don't hesitate to reach out if you have any questions - support@orbital-systems.com.
Use the kit below to swap the diverter. This kit is available in several color variants.
Diverter body |
Diverter wall plate |
O-ring Ø15,54x2,62 Nitrile |
3 mm hex key tool (Allen key) |
Screw, set, M6 x 8 |
Screw ST4.2 x 50mm A2, TX 20 |
Screw ST4.2 x 45mm A2, TX 20 |
Screw ST4.2 x 38mm A2, TX 20 |
Dismantle diverter
Disconnect the hand shower from the diverter.
Loosen the screws on the bottom to release the diverter.
Caution
Hold the diverter to minimize the risk of falling.
Loosen the diverter body.
Screw down the wall plate.
Note
If the wall plate is undamaged, it should be reused and does not need to be dismantled, unless otherwise specified in the work order. This step and steps 1-2 under "Install diverter" only apply when replacing the wall plate.
Install diverter
Step 1-2 are only valid if the wall fixture should be replaced.
Clean the surface behind the diverter wall plate.
Fit the new wall plate.
Caution
Fill the holes with wet room silicone. The mount must be horizontal.
Mount the diverter body on the wall bracket by tightening the screws on the underside.
Caution
Apply fixture grease to the o-rings.
Install the hand shower hose.
Caution
Make sure the gasket is in good condition and has no damage.
Start the shower and let it run for a while. Switch between the head shower and hand shower, and ensure there is no leakage from the diverter.
Turn off the shower.
Complete and submit the service report (found in the service request).
Recycle the parts and components that should not be reused.
