12. Control Dial
This instruction shows how to swap the Control Dial in a Hatch Panel installation, where the Control Dial is placed on the door. Follow the instructions in detail, and don't hesitate to reach out if you have any questions - support@orbital-systems.com.
Use the kit below to swap the Control Dial. This kit is available in several color variants.
Control Dial with fixture and screws |
Disassemble Control Dial
Turn off the power.
Open the door.
Disconnect the Control Dial from the Core (red connector).
Draw the Control Dial cable from the cable channel.
Dismantle the Control Dial by clicking the lower part. Then draw the Control Dial together with the cable.
Unscrew the fixture.
Install Control Dial
Clean the surface behind the fixture.
Mount the new fixture.
Position the Control Dial according to the “up mark” for mounting.
Attach the Control Dial by adjusting the brackets according to the arrows. Make sure it clicks when attaching.
Route the cable through the cable duct to the Core.
Connect the Control Dial contact to the red communication port on the Core. The connector must be tightened by hand.
Caution
Ensure proper alignment between the connector and communication port. This must be done with special attention to prevent damage to the pins.
Close the door to the Wall Box.
Remove the protective film from the Control Dial.
Turn on the power. It may take up to 3 minutes for Core to start up.
Validate the Control Dial change by starting the shower and changing the temperature. The numbers on the Control Dial should follow during the temperature change.
Turn off the shower.
Complete and submit the service report (found in the service request).
Recycle the replaced components.
