16. Hatch Panel door
This instruction shows how to swap the Hatch Panel door. Follow the instructions in detail, and don't hesitate to reach out if you have any questions - support@orbital-systems.com.
Use the following kit to swap the Hatch Panel door. This kit is available in several color variants.
Door Hatch Panel ASM |
Hatch Panel door lock swap kit |
Dismantle door
Turn off the power.
Open the door.
Disconnect the Control Dial from the Core (red connector).
Draw the Control Dial cable from the cable channel.
Dismantle the Control Dial by clicking the lower part. Then draw the Control Dial together with the cable.
Unscrew the fixture.
Dismantle the hatch.
If needed, remove the bracket for the door lock in the Wall Box. The bracket should be reused and does not need to be replaced if it is undamaged.
Install door
Mount the new door. It should be screwed on with a total of eight nuts - four on the upper hinge and four on the lower.
Adjust the angle of the door by loosening the four nuts slightly. Tighten the nuts when the door is level.
Mount the new fixture.
Attach the Control Dial by adjusting the brackets according to the arrows. Make sure it clicks when attaching.
Route the cable through the cable duct to the Core.
Connect the Control Dial contact to the red communication port on the Core. The connector must be tightened by hand.
Caution
Ensure proper alignment between the connector and communication port. This must be done with special attention to prevent damage to the pins.
Install the door lock bracket in the upper right corner of the wall cabinet. Clean the surface before installing the bracket. This is only applicable if the bracket is to be replaced.
Assemble the remaining parts of the lock.
Put the door latch in the locked position and close the door.
Remove the protective film from the Control Dial.
Turn on the power. It can take up to 3 minutes for the Core to start up.
Validate the Control Dial change by starting the shower and changing the temperature. The numbers on the Control Dial should follow during the temperature change.
Turn off the shower.
Complete and submit the service report (found in the service request).
Recycle the parts and components that should not be reused.
