Skip to main content

User Guide

Clean the drain

Needed tools: Cleaning agents

Caution

Do not use any corrosive detergents or abrasive pads/cloths as it might damage the Sensor Tank.

  1. 200109_SIT_remove_gitter_drain.eps
  2. 240306_SIT_remove_tank_lock.eps
  3. 240306_remove_water_trap.eps
  4. Use non-abrasive cleaning agents only. Make sure to clean all surfaces of each component, including the drain unit.

    210511_SIT_clean_tank.eps
  5. Rinse thoroughly with water. Use water from an other source than the shower.

    210308_SIT_rinse_tank.eps
  6. 210618_SIT_insert_water_lock.eps
  7. Notice

    Make sure the O-ring is correctly mounted before reassembly of the Sensor Tank.

    231220-Sensor_tank_oring.eps
  8. Insert Sensor Tank. Lock the Sensor Tank in position with the Sensor Tank lock by turning it 90 degrees.

    Caution

    Make sure the Sensor Tank is inserted correctly. Its edge should be fully pushed towards the drain unit's edge.

    240306-Lock_Sensor_Tank.eps
  9. Notice

    Place the Funnel with the hole oriented to the left! Placing the hole oriented to the right will disable recirculation.

    210302_SIT_Insert_Gitter.eps