Install Control Dial
 |
Cut the conduit flush to the tile surface.
Level the fixture and make sure it is centered on the hole in the wall.
Drill 4 holes (4,0 mm) in marked locations. Make sure that it is the outer holes in the fixture that is used.
Caution
Only drill through the tile itself, no deeper.
Seal drill holes according to industry rules. See section Seal mountings in wet zone for instruction.
x4
TX screw A4 (38 mm)
Connect the Control Dial cable to the extension cord.
Notice
Do not remove the protective cover from the Control Dial until the installation is completed.
Pull the cable through the conduit.
Notice
It is recommended to use fish tape to route the cables through the pipes.
Position the Control Dial according to the “up marking” before assembly.
"Click!" Snap on the Control Dial onto the fixture. Make sure to align the brackets according to the arrows.
Connect the Control Dial cable to the red connector. Proceed by connecting the Sensor Tank cable to the blue connector.
Caution
Make sure to have correct alignment between key and slot in connectors. Make sure locking ring snaps and connector is locked.
Only valid for Orbital Audio Installation
Connect the amplifier cable to the Core.
