Skip to main content

Orbital Shower Installation

Pipes and connections
210519_pipes_and_connection_comp_overview.eps
. Provided by customer:

  • PEX hose with conduit Ø25 mm

  • Power cable with conduit Ø16 mm

  • Anchors

  1. Cut the cones depending on the diameter of the conduit.

    200124_pipes_and_connection_cut_cone_millimeter.eps
  2. 201124_R3_pre_inst_13.eps

  3. Cut the conduits.

    Caution

    Cut the conduits as close as possible to the cones.

    200124_pipes_and_connection_cut_sleeves_millimeter.eps

  4. Notice

    Anchors provided by Customer.

    200124_pipes_and_connection_anchors.eps

  5. Cut the PEX.

    Notice

    Length might be adjusted depending on the chosen connector applied later.

    201124_pipes_and_connection_cut_pipes_millimeter.eps

  6. Warning

    Electrical installation should be performed according to industry rules by a competent electrician.

    200124_pipes_and_connection_electrical.eps

  7. Install the wifi antenna. If using an Ethernet connection, see the next step.

    210420_R3_wall_integrated_mount_wifi_antenna.eps

  8. Only valid for Orbital Ethernet installation

    220311_Panel_ethernet_connector_comp_overview.eps
    220309_Panel_Install_Ethernet_remove_antenna.eps
  9. 220309_Panel_Install_Ethernet_connector.eps
  10. 220309_Panel_Install_Ethernet_flex_hose.eps