Skip to main content

Installation

Installing the shower head

Figure 119. Component Overview
Component Overview


  1. Threaded adapter

  2. Head shower internal PEX pipe

  3. Shower head

  4. Head shower arm insert

  5. O-ring

  6. Shower head arm

  1. Cut the wallbox UNI Push so that it protrudes 6-9 mm. We recommend using the LK Wallbox Cutter UNI.

    241202_shower_head_inst_1.eps

  2. Fit the threaded adapter into the UNI Push wallbox. It should protrude 30-55 mm from the wall surface; cut it if needed.

    Notice

    Cover the end of the threaded adapter with thread sealant to avoid leakage.

    241202_shower_head_inst_2.eps

  3. Fit the head shower arm insert onto the adapter.

    241202_shower_head_inst_3.eps

  4. Adjust the angle using the set screws.

    Notice

    The head shower will add some weight. Adjust the angle of the arm slightly upwards to compensate for the added weight.

    Spänn/lossa stoppskruvarna för att justera vinkeln. Kontrollera med vattenpass.

    241202_shower_head_inst_4.eps

  5. Push the PEX pipe into the shower arm insert. Be careful not to break the *studs*.

    För in PEX-röret i insatsen.

    241202_shower_head_inst_5.eps

  6. Fit the metal cover over the shower arm insert.

    Trä metallhylsan över insatsen.

    241202_shower_head_inst_6.eps

  7. Fit the shower head onto the shower head arm.

    Caution

    Make sure not to cross thread and not to overtighten.

    201118_head_shower_install_3.eps